TINY AUDIO C10 User Guide
10
1.4 Fit the DAB antenna
As the DAB antenna is designed to be attached once only, if the DAB antenna is
removed, it will not adhere again; therefore, it is recommended that you try fitting
the DAB antenna on the chosen location first before attaching the antenna
permanently.
a. Fit the Antenna for a location according to 1.1 to 1.3 above.
b. Mark the position of Signal Booster on the windshield for the
2. Permanent Installation
You should complete reviewing the pre-installation section and fit the antenna before
you begin the permanent installation of this DAB antenna.
2.1 Clean the windshield
Ensure the chosen antenna location on the windshield is clean and free of dirt,
water, and other substance which will help the antenna adhere to your car
windshield properly. Clean the glass with alcohol prep pad, and wait until the
surface is completely dry before attaching the glass-mount DAB antenna.
Note:
Do not use a cleaner with surfactant to clean the windshield because
Antenna and the Signal Booster may not stick to the glass.
2.2 Installation Procedure
Metal Frame of A Pillar
Dotted Area
Black Shade
To Next Page
Loading...
