TOA-DKK CD-36D - 3.2 Filling of Sodium Chloride Tablets

Model: CD-36D 3.2 Filling of Sodium Chloride Tablets
- 11 -
③ Clean the threads of the cap. ⋅⋅⋅⋅⋅⋅ Immerse the cap in water to make beads attached on threads
settle in cap and to clean the threads so that no beads remain on the threads.
④ Put the cap back. ⋅⋅⋅⋅⋅⋅ Reinstall the cap on the top of the detector paying attention not to spill
beads from the cap.
⑤ Return the detector to the original state. ⋅⋅⋅⋅⋅⋅ Insert the detector slowly and vertically into the
flow cell until it touches the bottom of the flow cell, and connect the connector of the detector lead
wires like before if it was disconnected to remove the detector.
3.2 Filling of Sodium Chloride Tablets
(For specifications with a conductivity modifying column (option))
In order to achieve stable measurement when the conductivity of a sample is in the neighborhood of 3
8 mS/m or less, a conductivity modifying column (Model: CLZ-2) is provided to be combined as
option. In this case, fill sodium chloride tablets as shown below.
Lid
Container
Cell
Filter
Sample Outlet
Sample Inlet
Sodium Chloride Tablets
Code No.: 143A203
(Supplied as option)
Filling of Sodium Chloride Tablets