TOA-DKK CD-36D - 3.3 Introduction of Sample Water

Model: CD-36D 3.3 Introduction of Sample Water
- 12 -
① Fill the container with sodium chloride tablets. ⋅⋅⋅⋅⋅⋅ Open the lid of the container and fill it with
sodium chloride tablets to its level of ca. 80%.
② Close the lid. ⋅⋅⋅⋅⋅⋅ Close the lid tight.
• The lid must be closed securely when introducing the sample water.
3.3 Introduction of Sample Water
Detector
Flow Cell
Sample Inlet
Sample Outlet
(Flow Rate: ca. 100mL/min)
Introduction of Sample Water to the Sensor
① Confirm that the sensor is ready for introduction of the sample water. ⋅⋅⋅⋅⋅⋅ Confirm that the
sample line is correctly connected the sample inlet and the detector is fixed properly.
② Introduce the sample water. ⋅⋅⋅⋅⋅⋅ Introduce the sample water to the sensor and confirm that the
sample is flowing under the following conditions.