38
Step 7. The following message will be displayed upon update completion.
8.13.4. Setting restoration
Updating firmware may invalidate settings made before the update. In such cases, restore the settings using
the following procedure:
Step 1. Delete all of the setting contents. (Refer to p. 22, Initialization.)
Step 2. Reset the Unit ID number. (Refer to p. 16, Unit ID Number Setting and Confirmation.)
Step 3. Activate the setting software and open the setting file.
Step 4. Click on [Remote (R) ā Bulk transmission (T)].
When the transmission is finished, the settings will be restored.
8.14. Internal Memory Programming Precautions
Set data are stored in the unit's internal memory. The decimal point of the first digit on the Memory/Unit ID
Number display flashes while programming data into the internal memory. Data may be lost if the unit's power
is switched off or the Reset button is pressed during this operation.
Avoid switching off the unit's power or pressing the Reset button while the first digit decimal point on the
Memory/Unit ID Number display is flashing.
Care does not need to be taken during normal operation. However, when a large volume of set data is being
transmitted from a PC through bulk transmission, the process of writing into internal memory continues for
approximately 1 minute. Therefore, do not switch off the power or press the Reset button during this duration.
To Next Page
Loading...
Need help?
General
