39
8.15. Memory/Unit ID Number Display Indication at Activation
The Memory/Unit ID Number Display's indication changes in the following order after the power has been
switched on or the Reset button pressed.
(1) "8.8." (All indicators ON)
(2) "dP"
(3) "CH", "C1", "C2" or "C3"
(Refer to p.23, RS-485 Communication Speed.)
(4) "1.7", etc. (Firmware's version number)
(5) "16", etc. (Current pattern memory)
Notes
• When no Unit ID number is set, the "Id" indication flashes in (5).
• When the RS-232C communication port is set to permit the connection of
the DK-1608 Memory Selector (refer to p. 24, Recalling Pattern Memory
Using the Memory Selector), the "oP" indication is displayed between (4)
and (5).
To Next Page
Loading...
Need help?
General
