Tomberlin CrossFire 150 - Page 56

GENERATOR ASSEMBLY COMPONENTS
1. Cooling fan
2. Generator assembly
3. Flywheel comp.
4. Stator comp.
5. Washer
6. Bolt
7. Nut
8. Bolt
9. Bolt
STATOR INSPECTION
Note: Inspection work can be done on the engine without removing the generator.
• Remove the 4-pin connector of the generator.
• Remove the 2 bullet connectors.
• Measure the resistance value between the wire and engine ground.
White 0.2 ~ 0.4Ω (20º C)
Yellow 0.1 ~ 0.8 Ω
Blue & Yellow 148 Ω
Black & Red 502 Ω
Black ∞
When the measured value is more than the standard value, the coil should be replaced.
52