Check for any damage or corrosion.
Check motor rubber cover for holes, tears or cuts.
1.Rotors, buckets and racks
①
②
Check chamber lid gasket for any damage or deformation.
③
※
Check that it is less than twice the standard deceleration time. (See "11-1. Acceleration and
Deceleration Times" in this Operator's Manual.)
<
To inspect the unit
>
2.Chamber interior
Check for any damage or deformation.
①
3.Motor shaft
Check for any damage, deformation or corrosion.
①
Check for any damage, deformation or corrosion.
Check all nuts and bolts for any loose.
①
②
Check lid hook for damage, deformation or corrosion.
③
4.Main unit exterior
Check the deceleration time using rotors available for your unit.
①
5.Brake
To Next Page
Loading...
