TH2523 Series Operation Manual Ver1.2
46
6.3 USBTMC Remote Control System
USB (Universal Serial Bus) remote control system controls the instrument through the USB
interface. This connection conforms to USBTMC-USB488 and USB2.0 protocols.
6.3.1 System Configuration
Connect USB interfaces on PC and TH2523 through a USB cable.
6.3.2 Install the Driver
When TH2523 is first connected to a PC through a USB cable, the prompt information –Found
New Hardware will show on the right bottom of the computer desktop, as is shown below:
Figure 6-5 Procedure 1 of Installing USB Driver
Click “NEXT”, dialogue 6-6 will pop up. Choose “Install the software automatically
(recommended)”.
To Next Page
Loading...
