Tonghui TH2523/A - Use of Test Fixture; Warm-Up; Other Features

TH2523 Series Operation Manual Ver1.2
3
1.6 Use of Test Fixture
Only use the test fixture or cable made by our company, because the use of other test fixtures
or cables may result in incorrect measurement results. In addition, for good contact of DUT
and fixture, keep the test fixture or cable and pins of DUT clean.
Connect the test fixture or cable to L
CUR
, L
POT
, H
POT
and H
CUR
terminals on the instrument
front panel. Pay attention to the direction when inserting the test fixture to avoid abnormal
measurement.
1.7 Warm-up
（1） For accurate measurement, the warm-up time should not be less than 30 minutes.
（2） Do not turn on or off the instrument frequently. This may cause internal data
confusion.
1.8 Other Features
（1） Consumption: ≤10VA.
（2） Dimensions（ W*H*D）： 235mm*105mm*360mm; This dimension is the final
packaging size.
（3） Weight: Approx. 3.6kg.