Tonghui TH2523/A - Statistical Analysis Commands

TH2523 Series Operation Manual Ver1.2
64
Query syntax: BINSETup:NORmalB?
Return value: <NR3><NL^END>
<NR3> the secondary parameter
The:BINSETup:BINA command set the upper and lower limit of the primary parameter.
According to different modes, the upper and lower limit of absolute value or percentage can
be set. The:BINSETup:BINA? query returns the current limit of current mode.
Command syntax: BINSETup:BINA N:<value,value>
N Bin number, ranges from 1~9.
<value,value> the upper and lower limit of the primary parameter
For example: WrtCmd(“BINSETup: BINA 2:15,10”);set the upper limit value of primary
parameter in BIN2 as 15 and the lower limit as 10.
Query syntax: BINSETup: BINA N?
Return value: <NR3><NL^END>
<NR3> the upper and lower limit of the primary parameter
The:BINSETup:BINB command set the upper and lower limit of the secondary parameter.
According to different modes, the upper and lower limit of absolute value or percentage can be
set. The:BINSETup:BINB? query returns the current limit of current mode.
Command syntax: BINSETup:BINB N:<value,value>
N Bin number, ranges from 1~9.
<value,value> the upper and lower limit of the secondary parameter
For example: WrtCmd(“BINSETup: BINB 2:15,10”);set the upper limit value of secondary
parameter in BIN2 as 15 and the lower limit as 10.
Query syntax: BINSETup: BINB N?
Return value: <NR3><NL^END>
<NR3> the upper and lower limit of the secondary parameter
7.1.8 Statistical Subsystem Commands
Statistical subsystem commands are used to count the measurement result or to set statistical
funtion.
Command Tree: