Tonghui TH2523/A - Function and Measurement Control

TH2523 Series Operation Manual Ver1.2
50
Functions of <page name> are as follows：
MEASurement Set the display page to the basic measurement.
BCOMP Set the display page to bin comparator.
TSWEEP Set the display page to trace sweep.
STATistics Set the display page to statistics.
MSETup Set the display page to measurement setup.
BinSETup Set the display page to bin setup (this command is invalid).
TSETup Set the display page to trace setup.
SYSTem Set the display page to system setup.
FLISt Set the display page to (internal) file list.
The :STATe command is used to select whether to refresh the measurement display result in
measurment display page.
Command Syntax: ON（0）
DISPlay:STATe
OFF（1）
Query syntax: DISPlay:STATe?
Return format: <NR1><NL^END>
<NR1> is as follows:
1
2
7.1.2 FUNCtion Subsystem Commands
FUNCtion subsystem commands are mainly used to set “function”, “range”, “speed”, current
and voltage monitoring switch, mode selection of deviation display, nominal setup, etc..
Command Tree: