Topcon OS-101 - Page 125

119
20. CHANGING THE SETTINGS
3. "SHV" and "NEZ" tabs of <Set out Coords>
Page 1 [ OK ] [ --- ][CNFG] [MEAS]
Page 2 [ --- ] [ --- ] [ --- ] [ --- ]
Page 3 [ --- ] [ --- ] [ --- ] [ --- ]
 The following functions can be allocated to the softkeys.
[ --- ] : No functions set
[MEAS] : Distance and angle measurement
[CNFG] : Set setting out accuracy (can only be allocated to 2 and 3 above)
[SHV] : Switch the "SHV" tab and "SHVdist" tab (can only be allocated to 1 above)
[SHVR] : Switch distance mode between slope distance (SD)/horizontal distance (HD)/height
difference (VD)/REM (R) in setting out screens. The capitalized letter in the softkey
indicates the currently selected mode (can only be allocated to 2 above).
[OK] : Terminate setting out measurement for the selected setting out point and return to
<Key in coord>. This setting out point will be removed from the list (can only be
allocated to 3 above).
[0SET] : Set horizontal angle to 0°
[H-SET] : Set required horizontal angle
[R/L] : Select horizontal angle right/left. The capitalized letter in the softkey indicates the
currently selected mode.
[ZA / %] : Switch between zenith angle/slope in %. The capitalized letter in the softkey indicates
the currently selected mode.
[HOLD] : Hold horizontal angle/release horizontal angle
[CALL] : Display final measurement data
[HVOUT-S] : Output angle measurement results to an external device (SET format)
[HVDOUT-S] : Output distance and angle measurement results to an external device (SET format)
[NEZOUT-S] : Output coordinates data to an external device (SET format)
[HVOUT-T] : Output angle measurement results to an external device (GTS format) (can only be
allocated to 1 above)
[HVDOUT-T] : Output distance and angle measurement results to an external device (GTS format)
(can only be allocated to 1 above)
[NEZOUT-T] : Output coordinates data to an external device (GTS format) (can only be allocated to
1 above)
[F/M] : Switch distance units between meters/feet
[HT] : Set the instrument station, coordinates and instrument height
[S-LEV] : Return signal
[TILT] : Display tilt angle
[EDM] : EDM settings
[MENU] : Display <Menu> (coordinate measurement, setting out measurement, offset
measurement, REM measurement, missing line measurement, resection, area
calculation)
[COORD] : Coordinates measurement
[S-O] : Setting-out measurement
[OFFSET] : Offset measurement
[A-OFS] : Angle offset measurement
[D-OFS] : Distance offset measurement
[2D-OFS] : Offset/2D measurement
[MLM] : Missing line measurement
[REM] : REM measurement
[RESEC] : Resection measurement
[AREA] : Surface area measurement