Toptech MultiLoad II EXL - Page 63

CHAPTER 6– CONFIGURATIONS
63 MultiLoad II/ RCU II Explosion Proof Lite (EXL) Installation Guide - Part # 6070
3) Go to program mode by entering 00000 on the keypad, then press Next.
A MultiLoad II must have the Program switch set to allow access to Program Mode (See section
6.1).
00000 is the factory default access code. See the “MultiLoad II User Guide,” RCU General
Setup section for changing or adding new access codes.
Note that unlike MultiLoad II, Program switches or CPU DIP switches never deny access to
RCU II Program Mode.
4) The program mode main menu displays the following:
MultiLoad II
RCU II
5) Press Enter to access the Configuration menu.
6) Press Enter to access RCU General Setup/ RCU Setup:
For Access
Insert Driver Card
M A I N M E N U
Configuration
Diagnostics
Views and Inquiries
SD Card
Factory Defaults
Next Prev Exit Enter
M A I N M E N U
Configuration
Diagnostics
Factory Defaults
SD Card
Next Prev Exit Enter