Workman 1100/1110/2100/2110 Page 6 – 3 Electrical System
Special Tools
Order special tools from the TORO SPECIAL TOOLS
AND APPLICATIONS GUIDE (COMMERCIAL PROD-
UCTS). Some tools may also be available from a local
supplier.
Multimeter
The meter can test electrical components and circuits
for current, resistance, or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt–
Ohm–Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Figure 1
Skin–Over Grease
Special non–conductive grease (Toro Part No. 505–47)
which forms a light protective skin which helps water-
proof electrical switches and contacts.
Figure 2
Electrical
System