Toro 07253 Service Manual

Workman 1100/2100/2110
Drive Train
Page 5 – 14
Check Driven Clutch Spring Torsion
1. Park machine on a level surface, stop engine, set
parking brake, and remove key from the ignition switch.
2. Place transaxle in gear to prevent the fixed sheave
from moving.
3. Remove drive belt from the driven clutch (see Ser-
vice Drive Belt in Engine Chapter).
IMPORTANT: Use protective strips of soft metal
when clamping the moveable sheave with locking
pliers to prevent damage to the sheave.
4. Clamp moveable sheave with locking pliers.
5. Measure spring torsion.
A. Pull scale tangentially to the outer diameter of the
moveable sheave.
B. When the button on the ramp of the moveable
sheave is 0.125 inch (3.18 mm) from the ramp of the
fixed sheave, read the scale.
C. The reading should be 16 to 20 lbf (71 to 89 N).
6. If the above specification is not met, replace the driv-
en clutch.
1. Moveable sheave
2. Drive belt
3. Button
4. Ram
p
(
fixed sheave
)
Figure 18
4
3
2
1
Change Transaxle Fluid
Note: Perform this maintenance procedure at the in-
terval specified in the Operator’s Manual or Chapter 2
– Product Records and Maintenance.
1. Park machine on a level surface, stop engine, set
parking brake, and remove key from the ignition switch.
2. Remove drain plug from the right side of the trans-
axle case. (Fig. 19) Let fluid flow into a drain pan.
3. When fluid stops draining, reinstall and tighten drain
plug (Fig. 19). Torque plug from 15 to 18 ft–lb (21 to 25
N–m).
4. Use 10W–30 motor oil to fill the transaxle case.
A. Fill case with about 1.5 quarts (1.4 liters) of motor
oil (Fig. 20).
B. Or, fill case until oil level is at the bottom level of
the indicator hole with the plug removed (Fig. 19).
5. Reinstall level indicating plug and fill cap. Tighten
plugs that were removed (Fig. 19 and 20).
6. Start engine and operate vehicle to allow the trans-
axle to fill. Recheck oil level. Replenish oil if required.
1. Drain plug 2. Level indicating plug
Figure 19
1
2
15 to 18 ft–lb
(21 to 25 N–m)
1. Fill cap 2. Driven clutch
Figure 20
1
2

Toro 07253 Specifications

General

Brand	Toro
Model	07253
Category	Utility Vehicle
Language	English