Toro 07253 Service Manual

Rev. B
Workman 1100/1110/2100/2110 Page 6 – 17 Electrical System
Installation
1. Install pulley to the starter/generator shaft (Fig. 21).
A. Position spacer and woodruff key onto the shaft.
Place pulley onto the shaft.
B. Secure pulley to the shaft with spring washer and
nut. Torque nut from 15 to 25 ft–lb (20 to 34 N–m).
2. Position starter/generator to the engine mount.
A. Insert pivot bolt through the engine mount, start-
er/generator front bracket, pivot, and starter/genera-
tor rear bracket.
B. Install flanged lock nut onto the pivot bolt.
C. Tighten lock nut enough so starter/generator piv-
ots with slight resistance.
3. On the Workman 2100 and 2110 (Fig. 19):
A. Insert end of starter rod with jam nuts through the
torque arm.
B. Secure starter rod to the starter/generator with
the cotter pin.
4. On the Workman 1100 and 1110 (Fig. 20):
A. Install carriage bolt through starter flange and
starter bracket.
B. Thread flange nut onto carriage bolt.
5. Correctly connect all wires to the starter/generator.
6. Install V–belt to the pulley. Adjust V–belt (see Adjust
Starter/Generator Belt in Engine Chapter).
1. Starter/generator
2. Flanged lock nut
3. Pivot bolt
4. Pivot
5. Engine mount
6. Nut
7. Lock washer
8. Pulley
9. Woodruff key
10. Spacer
Figure 21
4
3
2
5
1
7
6
8
9
10
15 to 25 ft lbs
(20 to 34 N–m)
Electrical
System

Toro 07253 Specifications

General

Brand	Toro
Model	07253
Category	Utility Vehicle
Language	English