EasyManua.ls Logo

Toro 30605 - Pushing or Towing the Machine; Locating the Jacking Points; Hauling the Machine; Locating the Tie-Down Points

Toro 30605
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PushingorTowingthe
Machine
Inanemergency,themachinecanbemovedforwardby
actuatingthebypassvalveinthevariable-displacement
hydraulicpumpandpushingortowingthemachine.
Important:Donotpushortowthemachinefasterthan3
to4.8km/h(2to3mph),becauseinternal-transmission
damagemayoccur.Thebypassvalvesmustbeopen
wheneverthemachineispushedortowed.
1.Raisetheseatandlocatethebypassvalves,whichare
locatedbelowthefrontofthefueltank(Figure30).
Figure30
1.Bypassvalve
2.Rotateeachvalve3turnscounter-clockwisetoopen
andallowoiltobypassinternally.
Note:Donotopenmorethan3turns.Becauseuid
isbypassed,themachinecanbeslowlymovedwithout
damagingthetransmission.
3.Closethebypassvalvesbeforestartingtheengine.
4.Torqueto70N∙m(52ft-lb)toclosethevalve.
Important:Ifyoumustpushortowthemachinein
reverse,bypassthecheckvalveinthe4-wheeldrive
manifold.Tobypassthecheckvalve,connectahose
assemblythatconsistsofahose(PartNo.95-8843),2
couplerttings(No.95-0985),and2hydraulicttings
(No.340-77)tothereverse-traction,pressure-testport,
locatedonthehydrostat,andtotheportlocatedbetween
portsM8andP2onthereartractionmanifold,located
behindthefronttire.
LocatingtheJackingPoints
Therearejackingpointslocatedatthefrontandrearofthe
machine.
WARNING
Alwaysusejackstands.Donotrelyonajackor
hoisttoholdthemachine.
Mechanicalorhydraulicjacksmayfailtosupport
themachineandcauseaseriousinjury.
Ontheframeattheinsideofeachfrontdrivetire
Atthecenteroftherearaxle
HaulingtheMachine
Usecarewhenloadingorunloadingthemachineintoa
traileroratruck.
Usefull-widthrampsforloadingthemachineintoa
traileroratruck.
Tiethemachinedownsecurelyusingstraps,chains,cable,
orropes.Bothfrontandrearstrapsshouldbedirected
downandoutwardfromthemachine.
LocatingtheTie-DownPoints
Therearetiedownslocatedatthefrontandrearsidesofthe
machine(Figure31).
Note:Useproperly-ratedDOT-approvedstrapsin4corners
totiedownthemachine.
2onthefrontoftheoperator'splatform
Rearbumper
Figure31
1.Reartie-downpoint2.Fronttie-downpoints
33

Table of Contents