Toro EVOLUTION Series - Set Monthly Adjust; Set Schedule as Grow In

18
4FU.POUIMZ"EKVTU
Use the monthly adjust function to allow EVOLUTION
TM
to automatically increase or decrease your watering with respect to the seasons
for all zones assigned to the schedule. During the winter and spring months, it may be necessary to decrease watering. In the summer
months, it might be necessary to increase watering.
Step 1 – While in the ADVANCED/SCHEDULE DETAILS menu, use the Up or Down arrows to select the Schedule you
want to edit. Press SELECT
.
Step 2 – Use the Up
or Down arrows to navigate to MONTHLY ADJUST. Press SELECT .
Step 3 – Use the Up
or Down arrows to select the month you want to edit. Press SELECT . Use the Up or
Down
arrows to enter the percentage you want your watering duration to increase or decrease. Press SELECT to save.
Repeat Step 3 for the remaining months as necessary.
MONTHLY ADJUST
JANUARY -15%
FEBRUARY ---
MARCH ---
APRIL ---
MAY ---
As an example, a runtime of 10 minutes with an adjustment of +50% will increase the actual runtime to 15 minutes. Similarly,
an adjustment of -50% will decrease the runtime to 5 minutes.
4FU4DIFEVMFBT(SPX*O
Use the Grow In function to set the schedule to water continuously for an extended period of time.
Step 4 – Use the Up
or Down arrows to select the proper value. Press SELECT to save.
START – Enter the start time of the cycle.
END – Enter the end time of the cycle.
RUNTIME – Enter the duration the cycle will run. Set runtime in hours and minutes (HH:MM).
DELAY – Enter the duration between each cycle. Set delay in hours and minutes (HH:MM).
END AFTER – Enter the number of days the cycle will repeat. Select from 1-90 days.
GROW IN
START 07:00AM
END 05:00PM
RUNTIME 00:05
DELAY 00:20
END AFTER 10 DAYS
Note: Restricted days will not aect the Grow In schedule but an activated rain sensor will.