Toro ProPass 200 - Service and Repairs; Engine

ProPass 200Page 6 -- 12Hydraulic Power Pack
Service and Repairs
Engine
1. Jaw coupling (engine)
2. Spider coupling
3. Jaw coupling (gear pump)
4. Square key
5. Engine
6. Flange adapter
7. Engine mount plate
8. Mount bracket (4 used)
9. Flange nut (2 used)
10. Cap screw (2 used)
11. R--clamp (2 used)
12. Engine wire harness
13. Generator bracket
14. Lock nut (2 used)
15. Cap screw (2 used)
16. Flat washer (2 used)
17. Cap screw (2 used)
18. Flat washer (10 used)
19. Flat washer (2 used)
20. Lock nut (4 used)
21. Cap screw (2 used)
22. Cap screw (4 used)
Figure 5
22
20
18
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
19
21
18
18
18
18
22
GROUND CABLE
CONNECTION
FRONT
RIGHT
Engine Removal (Fig. 5)
1. Position machine on a level surface. If ProPass is at-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
2. To prevent unexpected machine operation, discon-
nect the negative battery cable from the battery termin-
al. Position disconnected negative cable away from the
negative battery terminal.