Toro ProPass 200 - Information; Power Pack Relief Valve

ProPass 200Page 6 -- 20Hydraulic Power Pack
Power Pack Relief Valve
Figure 12
1. Hydraulic relief valve manifold
2. Hydraulic hose
3. Hydraulic hose
4. Hydraulic tube
5. Hydraulic hose
6. Cap screw (2 used)
7. Flange nut (2 used)
8. Straight hydraulic fitting (4 used)
9. Engine mount plate
10. Gear pump
11. Oil filter
12. Hydraulic hose (from tank)
13. Hydraulic hose (to tank)
9
11
4
5
7
10
1
3
12
8
2
6
8
13
FRONT
RIGHT
Removal (Fig. 9)
1. Position machine on a level surface. If ProPass is at-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components in the Service
and Repairs section of Chapter 3 -- Hydraulic System.
CAUTION
Before disconnecting any hydraulic compo-
nents, operate all hydraulic controls to relieve
system pressure and avoid injury from pressur -
ized hydraulic oil. See Relieving Hydraulic Sys-
tem Pressure in the General Information section
of Chapter 3 -- Hydraulic System.