Toro ProPass 200 - Page 87

ProPass 200 Page 5 -- 5 Chassis
Disassembly (Fig. 1)
1. Position machine on a levelsurface.IfProPassisat-
tached to tow vehicle, apply tow vehicle parking brake,
stop engine and remove key from the ignition switch.
Chock wheels to prevent ProPass machine from mov-
ing.
2. If front rinse guard is to b e r emoved from machine
with electronic controls (Fig. 2):
A. Disconnect E--stop button from machine wire
harness.
B. Remove fasteners that secure control panel
guard to machine. Remove control panel guard.
C. Remove t he two (2) cap screws, lock washers
and flat washers that secure hydraulic control m ani-
fold to rinse guard.
D. Raise and support hydraulic manifold away from
rinse guard.
3. Using Figure 1 as a guide, remove necessary bed
guards from frame to allow access to floor drive com-
ponents.
Assembly (Fig. 1)
1. Secure all removed bed guards to frame using Fig-
ure 1 as a guide.
2. If front rinse guard was removed from machine with
electronic controls, secure hydraulic manifold, control
panel guard and E--stop button to machine (Fig. 2).
1. E--stop button
2. Control panel guard
3. Screw (2 used)
4. Flange nut (2 used)
5. Flat washer (2 used)
6. Cap screw (2 used)
7. Hydraulic manifold
8. Cap screw (2 used)
9. Lock washer (2 used)
10. Flat washer (2 used)
11. Front rinse guard
Figure 2
2
3
6
8
9
10
11
1
5
7
4
MACHINES WITH ELECTRONIC
HYDRAULIC CONTROLS
Chassis