7-9
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
HYDROSTATIC DRIVE SYSTEM
Drive
Hydrostatic Drive Belt
Removal
1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,
and remove key. Engage the parking brake.
2. Raise and support the unit so that the drive wheels are off the ground.
3. Remove the mower belt from the clutch, see “Mower Belt Replacement,” chapter 3, page 3-15.
4. Using a spring removal tool (Toro Part No. 92-5771), remove the drive idler spring from the slot in the frame.
Remove the spring from the drive idler arm and inspect for damage or wear (Figure 7).
5. Remove the clutch stop.
Figure 7
To Next Page
Loading...
