6-11
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
ENGINE
Engine
Kawasaki Engine
Removal
1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,
and remove key. Engage the parking brake.
2. Disconnect the battery.
3. Remove the engine guard.
4. Remove the muffler.
5. Remove the mower belt, see “Mower Belt Replacement,” chapter 3, page 3-15.
6. Remove the hydrostatic drive belt, see “Hydrostatic Drive Belt Removal,” chapter 7, page 7-9.
7. Disconnect the chassis wire harness from the main engine wire harness.
8. Disconnect the red wire from the starter (Figure 13).
9. Disconnect the black engine ground wire.
10. Disconnect the fuel supply line at the fuel pump.
11. Remove vent line at splice with Toro supplied hose.
12. Disconnect the throttle cable, see “Throttle Control Assembly Removal,” chapter 5, page 5-23.
13. Disconnect the choke cable see “Choke Control Assembly Removal,” chapter 5, page 5-26.
14. Remove the clutch mounting bolt and washer. Slide the clutch off the crankshaft.
15. Remove the engine pulley.
16. Remove the engine mounting bolts.
17. Lift the engine away from the frame.
Figure 13
To Next Page
Loading...
