Toro TIMECUTTER HD 75212 - Fuel Tank Removal and Installation

5-21
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
CHASSIS
Chassis
Fuel Tank
Removal
1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,
and remove key. Engage the parking brake.
2. Disconnect the battery terminals.
3. Remove the right and left side consoles, see “Left Console Removal,” chapter 5, page 5-6; see “Right
Console Removal,” chapter 5, page 5-8.
4. Re-install the fuel cap.
5. Remove the seat assembly (for ZX models) or the MyRIDE™ Platform Assembly (for MR models), see “Seat
- TIMECUTTER® HD ZX Models Only Removal,” chapter 5, page 5-11; see “Seat & MyRIDE™ Platform -
TIMECUTTER® HD MR Models Only Removal,” chapter 5, page 5-13.
6. Remove the fuel tank hold down rod and bolt (A) (Figure 25).
7. Disconnect the fuel supply line (B) and the vent line (C) (Figure 25) from the fuel tank.
8. Rotate and lift the fuel tank assembly from the machine.
Figure 25
A
B
C