5-32
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
CHASSIS
Motion Control Assembly
Removal
1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,
and remove key.
2. Raise and support the unit so that the drive wheels are off the ground.
NOTE: The console must be removed for access, see “Left Console Removal,” chapter 5, page 5-6; see
“Right Console Removal,” chapter 5, page 5-8.
3. Remove the two bolt securing the motion control handle to the motion control assembly (A) (Figure 40).
4. Disconnect the motion control damper from the motion control assembly (B) (Figure 40).
5. Disconnect the motion control linkage from the motion control assembly (C) (Figure 40).
Figure 40
To Next Page
Loading...
