7-13
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
HYDROSTATIC DRIVE SYSTEM
Drive
Hydrostatic Drive Transmission
Removal (Right side shown)
NOTE: These steps are shown replacing the right side hydrostatic drive transmission. All of the same
steps apply to the left side hydrostatic drive transmission.
1. Stop the engine, wait for all moving parts to stop, and remove key. Engage the parking brake.
2. Disconnect the battery cables.
3. Raise and support the unit so that the drive wheels are off the ground.
4. Remove the drive wheel(s).
5. Remove the drive belt, see “Hydrostatic Drive Belt Removal,” chapter 7, page 7-9.
6. Disconnect the motion control linkage from the transmission (Figure 11).
Figure 11
To Next Page
Loading...
