8-18
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
MOWER DECK
Electric PTO Clutch (Cont.)
Installation
1. Install the clutch on to the crankshaft ensuring that the slot in the clutch aligns with the tab on the clutch anchor
and the rubber isolator is in place (Figure 18).
NOTE: Apply anti-seize to the end of the pulley shaft.
2. Apply thread lock to the clutch bolt.
3. Install the washer and clutch mounting bolt (F) (Figure 18). Torque the clutch bolt to 55 ± 5 ft-lbs. (76 ± 7 Nm).
4. Connect the clutch power wire to the clutch.
Figure 18
A. Engine Pulley to Shaft
(Apply Anti-Seize)
B. Bolt, Clutch Stop Mount
C. Clutch Stop
D. Clutch Isolator
E. Clutch PTO
F. Clutch Mounting Bolt
(Apply Loctite)
To Next Page
Loading...
