6-6
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
ENGINE
Toro Twin Cylinder Engine (Cont.)
Installation
1. Prepare the frame and secure any fuel lines or wire harness components.
2. Lower the engine onto the frame.
3. Align the four holes of the engine base to the frame and attach the two rear mounting bolts and two at washers
loosely.
NOTE: Apply Loctite 243 to engine mounting bolts.
4. Attach the front bolt through the clutch anchor and into the engine base (Figure 7).
5. Install the three remaining engine bolts.
6. Torque the four engine mounting bolts to 450 ± 50 in-lbs. (52 ± 5.8 Nm).
7. Apply anti-seize to the clutch end of the crankshaft.
8. Install the engine pulley onto the crankshaft.
Figure 7
To Next Page
Loading...
