6-7
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
ENGINE
Engine
Toro Twin Cylinder Engine (Cont.)
Installation (Cont.)
8. Install the clutch on to the crankshaft ensuring that the slot in the clutch aligns with the tab on the clutch anchor
(Figure 8).
9. Install the washer (E) and clutch bolt (F) (Figure 8).
NOTE: Apply Loctite to the clutch bolt (F) (Figure 8).
10. Torque the clutch bolt to 50-60 ft-lbs. (69-83 Nm).
11. Connect the choke cable, see “Choke Control Assembly Installation,” chapter 5, page 5-27.
12. Connect the throttle cable, see “Throttle Control Assembly Installation,” chapter 5, page 5-24.
Figure 8
A. Engine Pulley
B. Clutch Stop
C. PTO Clutch
D. Clutch Isolator
E. Washer
F. Clutch Bolt
G. Screw
H. Flange Nut
To Next Page
Loading...
