5-23
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
CHASSIS
Chassis
Throttle Control Assembly
Removal
1. Park the machine on a level surface and disengage the PTO. Stop the engine, wait for all moving parts to stop,
and remove key. Engage the parking brake.
2. Disconnect the battery.
3. Remove the control panel assembly from the right console (Figure 27).
4. Pry the keeper tab on the throttle control assembly and unsnap the control from the console.
5. Loosen the clamp securing the throttle cable to the throttle plate (Figure 28).
6. Remove the throttle cable from the throttle plate, noting the position of the cable in the plate.
7. Pull the throttle cable assembly through the console and out of the machine.
Figure 27
Figure 28
To Next Page
Loading...
