7-16
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
HYDROSTATIC DRIVE SYSTEM
Hydrostatic Drive Transmission (Cont.)
Removal (Right side shown) (Cont.)
10. Remove the bolts securing the transmission to the hydro cross plate (A) (Figure 15).
11. Loosen the outer frame mounting bolts.
12. Loosen the two bolts connecting the transmission to the rear cross member (D) (Figure 14).
13. Remove the front mounting bolt (C) (Figure 14).
14. Support the transmission and remove the mounting hardware. Lower the transmission.
Figure 15
A. Front Inner Mounting Bolts to
Frame Bracket
B. Bottom Mounting Bolts to Cross
Plate
C. Front Mid Mounting Bolts to
Frame Bracket
D. Rear Mid Mounting Bolts to
Cross-member Rear
E. Outer Mounting Bolts to Frame
Bracket
E
B
B
A
D
D
C
A
C
E
To Next Page
Loading...
