3-20
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
MAINTENANCE
Changing the Blades (Cont.)
Installation
1. Install the blades, curved washers, and blade bolts onto the spindle shaft (Figure 15).
NOTE: The curved part of the blade must point upward.
NOTE: Install the curved washer cone toward the bolt head.
2. Torque the blade bolts to 105 ± 5 ft-lbs. (145 ± 7 Nm).
Figure 15
A. Sail Area of the Blade
B. Blade
C. Curved Washer
D. Blade Bolt
To Next Page
Loading...
