5-25
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
CHASSIS
Chassis
Throttle Control Assembly (Cont.)
Installation (Cont.)
5. Place the z bend of the throttle cable in the throttle plate on the engine in the position previously noted.
6. Place the cable under the cable clamp.
7. Ensure that the throttle control lever is in the fast idle position (Figure 31).
NOTE: Pull on the cable and verify the engine is at full throttle, then tighten the clamp.
8. Connect the battery terminals and verify proper function of the unit.
Figure 31
To Next Page
Loading...
