7-5
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
HYDROSTATIC DRIVE SYSTEM
Drive
Neutral adjustment (Cont.)
8. Turn the adjustment nut on the motion control rod clockwise or counterclockwise until the drive wheel is slightly
rotating in reverse or not rotating at all. Repeat for both drive wheels if necessary (Figure 3).
NOTE: When the unit is in neutral, the stud should be roughly centered in the slot of the control plate
(Figure 4).
9. Stop the engine and lower the unit.
10. Verify proper neutral setting and tracking.
Figure 3
Figure 4
To Next Page
Loading...
