EasyManua.ls Logo

Toro Workman HDX-D - Before Operation; Before Operation Safety; Performing Daily Maintenance; Checking the Tire Pressure

Toro Workman HDX-D
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation
Before Operation
Before Operation Safety
General Safety
Never allow children or people who are not trained
or physically capable to safely operate or service
the machine. Local regulations may restrict the
age of the operator . The owner is responsible for
training all operators and mechanics.
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
Shut of f the machine, remove the key , and wait
for all movement to stop before you leave the
operator s position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
Know how to stop and shut of f the machine quickly .
Ensure that there are not more occupants (you and
your passenger(s)) than the number of handholds
equipped on the machine.
Check that all safety devices and decals are in
place. Repair or replace all safety devices and
replace all illegible or missing decals. Do not
operate the machine unless they are present and
functioning properly .
Fuel Safety
Use extreme care in handling fuel. It is ammable
and its vapors are explosive.
Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
Use only an approved fuel container .
Do not remove the fuel cap or ll the fuel tank
while the engine is running or hot.
Do not add or drain fuel in an enclosed space.
Do not store the machine or fuel container where
there is an open ame, spark, or pilot light, such
as on a water heater or other appliance.
If you spill fuel, do not attempt to start the engine;
avoid creating any source of ignition until the fuel
vapors have dissipated.
Performing Daily
Maintenance
Service Interval : Before each use or daily
Before starting the machine each day , perform the
Each Use/Daily procedures listed in Maintenance
( page 32 ) .
Checking the T ire Pressure
Service Interval : Before each use or daily
Front tires air pressure specication: 220 kPa (32
psi)
Rear tires air pressure specication: 124 kPa (18
psi)
Important: Check the tire pressure frequently
to ensure proper ination. If the tires are not
inated to the correct pressure, the tires will wear
prematurely and may cause the 4-wheel drive to
bind.
Figure 12 shows an example of tire wear caused by
under-ination.
g010294
Figure 12
1. Under-inated tire
Figure 13 shows an example of tire wear caused by
over-ination.
g010293
Figure 13
1. Over-inated tire
21

Table of Contents

Related product manuals