2Troubleshooting Procedures
SatelliteA660/ProA660 Series Maintenance Manual
51
The HDD/SSD or s lt. Either of these two
Procedure 1: Diagnostic test
eplacement check
Procedure 1
Run the Diagnostic Program, which will automatically execute the HDD/SSD R/W test.
tion
If an error is located, go to Procedure 2. If an error is not located, the HDD/SSD function is
Procedure 2 Connector and replacement check
The HDD module or system board may be disconnected or damaged. Disassemble the
orm
ystem board may be the reason of a HDD/SSD fau
components may be damaged. To determine if the computer’s HDD/SDD is functioning
properly, perform the following procedures. Figure 2-16 outlines the process. Start with
Procedure 1 and continue with the other procedures as instructed.
Procedure 2: Connector and r
Diagnostic test
(Refer to Chapter 3 system configuration check), Tests and Diagnostics for more informa
on the program.
functioning properly.
computer following the steps described in Chapter 4, Replacement Procedures, and perf
the following checks.
Check 1 Make sure that the HDD module is securely slotted into the system board. If the
problem persists, go to Check 2.
Check 2 The HDD module may be damaged. Replace it with a new one following the
instructions in Chapter 4. If the problem still exists, perform Check 3.
Check 3 The system board may be damaged. Replace it with a new one following the
instructions in Chapter 4.
To Next Page
Loading...
Need help?
General
