8 WHEN SOMETHING IS WRONG WITH THE EQUIPMENT
116 Daily Care for the Equipment
Daily Care for the Equipment
We recommend that you clean the following parts weekly so that the originals can always be scanned in unsoiled
conditions.
y Be careful not to scratch the parts when cleaning them.
y Do not use such solvents as thinner or benzine when cleaning the surface of the equipment.
- This could distort the shape of the surface or leave it discolored.
- When using a chemical cleaning pad, be sure to follow the instructions.
1. Scanning Area (surface of the long rectangular glass)
Wipe it with a soft dry cloth. If there are still stains remaining, wipe clean with a piece of soft cloth which has been
moistened with water and then squeezed well. Do not use solvents such as alcohol.
2. Original Glass
3. Guide
4. Platen Sheet
Clean the surface as follows depending on the extent of the staining.
- Clean it with a soft cloth.
- Clean it with a soft cloth lightly moistened with water.
- Clean it with a soft cloth lightly moistened with alcohol, and then wipe with a dry cloth.
- Clean it with a soft cloth lightly moistened with watered-down neutral detergent, wipe with a cloth moistened with
water, and then wipe with a dry cloth.
3
4
1
2
To Next Page
Loading...
Need help?
General
