1.TROUBLESHOOTING FOR THE HARDWARE
Refilling With Staples 59
1 TROUBLESHOOTING FOR THE HARDWARE
If the message “Check staple cartridge” remains, repeat the procedure above from step 1 to 10.
Refilling Saddle Stitch unit staples
When the staples of the stapler in the Saddle Stitch Finisher MJ-1030 have run out, refill staples following the procedure
below.
10
Join the Finisher to the equipment.
Move the Finisher slowly toward the equipment, placing both of
your hands on the front and the back of the Finisher.
1
Open the front cover of the Finisher.
2
Slowly pull out the Saddle Stitch unit.
3
Unlock the stapler of the Saddle Stitch unit by pulling
its handle toward you. Keep pulling the handle, and
turn the stapler clockwise by about 60 degrees.
The stapler is locked and cannot be turned any further when it lies
almost horizontally.
1
2
To Next Page
Loading...
Need help?
General
