1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Jam 35
1 TROUBLESHOOTING FOR THE HARDWARE
5
With the size indicated on the touch panel, check which paper size is registered for the
drawer.
6
Place the same size paper as the paper size indicated in the message.
7
The job is resumed.
When you change the paper size again after the job has been completed, make sure that the size of the paper
placed in the drawer is the same as the one registered in the equipment for the corresponding drawer.
4
Close the drawer and turn on the main power switch.
To Next Page
Loading...
Need help?
General
