Toshiba E-STUDIO 2500C - Selecting Finishing Modes; Type of Finishing Mode

3 SETTING OF BASIC COPY MODES
114 Selecting Finishing Modes
Selecting Finishing Modes
Type of finishing mode
The available finishing modes differ depending on the type of finishing device installed
(MJ-1030, MJ-1101, MJ-6004 or MJ-6101). Check the available finishing modes with the table
below.
Yes: Available
No: Not available
MJ-1030: Saddle Stitch Finisher
MJ-1101: Finisher
MJ-6004: Hole Punch Unit (for MJ-1030)
MJ-6101: Hole Punch Unit (for MJ-1101)
Finishing
device
Type of finishing mode
Sort/
Group
Rotate
sort
Staple
sort
Maga-
zine sort
Maga-
zine sort
& Saddle
stitch
Saddle
stitch
Hole
punch
MJ-1030 +
MJ-6004
Yes Yes Yes Yes Yes Yes Yes
MJ-1030 Yes Yes Yes Yes Yes Yes No
MJ-1101 +
MJ-6101
Yes Yes Yes Yes No No Yes
MJ-1101 Yes Yes Yes Yes No No No
No finishing
device
Yes Yes No Yes No No N o