9 BLINKING GRAPHIC SYMBOLS
346 Jam Symbols
Misfeed in the Saddle Stitch Finisher and the Hole Punch Unit
(optional: MJ-1030, MJ-6004)
The upper tray can be closed by
pressing the right side of the latch.
1
Hold up the guide and remove
any misfed paper in the paper
exit area.
When the Hole Punch Unit (optional: MJ-
6004) is installed, proceed to step 2. If
not installed, proceed to step 6.
2
Open the front cover of the
Hole Punch Unit.
3
Turn the green knob to locate
the triangle mark within the
area indicated on the label.
Under this condition, the punchers are
up.
To Next Page
Loading...
