Preparation 2- Setting Copy Paper 61
Changing the setting of paper size
If the setting of the paper size registered in the equipment does not correspond to the one in the
drawer, it could cause a paper jam. In this case, change the setting of the paper size according
to the following procedure.
2
Press the [USER] button on the touch panel to enter the user set-
ting menu and then press the [DRAWER] button.
3
Press the drawer on the touch panel corresponding to the one in
which the paper size has been set, and then press the button indi-
cating the new one.
1
Press the [USER FUNCTIONS]
button on the control panel.
To Next Page
Loading...
