Bypass Copying 93
5
Press the [START] button on the control panel.
Recalling dimensions registered in the memory
Press the desired memory number button from [MEMORY 1] to [MEMORY 4] to recall
the dimension data registered previously, and then press the [ENTER] button.
y Set other copy modes as required.
y Paper size that can be set is as follows:
Length: 100 mm to 297 mm
Width: 148 mm to 432 mm
y To register the dimension data in the memory, see P.94 “Registering non-stan-
dard size in the memory”.
To Next Page
Loading...
