December 2005 © TOSHIBA TEC e-STUDIO163/203 FIRMWARE UPDATING
6 - 3
6
6.1.1 PWA-DWNLD-350-JIG
[A] Update procedure
Important:
• Turn OFF the power before installing and removing the download jig.
• Do not turn OFF the power during the update. The data could be damaged and not be oper-
ated properly.
(1) Write the data to the download jig.
" P. 6-6 "6.1.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
(2) Turn OFF the power of the equipment.
(3) Remove the rear cover.
Fig. 6-4
(4) Connect the download jig with the connector (CN1) on the MAIN board.
Fig. 6-5
Rear cover
Connector
To Next Page
Loading...
