e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSIS MODES
2 - 8
[FAX] button: ON/[COPY] button: OFF ([FAX] LED: ON/[COPY] LED: OFF)
Digital
key
Button Items to check
Contents
Highlighted
display
e.g.
Normal
display
e.g.
[1]
A IPC board connection Not connected Connected
B MOT board connection Not connected Connected
C- --
D Key copy counter connection Not connected Connected
E Auto-toner sensor connection Not connected Connected
F Fuser unit connection Fuser unit
installed
Fuser unit not
installed
G Fuser unit initial detection fuse
disconnected
Other than
fuse
disconnection
H- --
[2]
A 24 V power supply Power ON Power OFF
B High-voltage power supply abnormality (shutdown)
detection
Normal Abnormal
C Main motor rotation status (Motor is rotating in Output
Mode (03))
Abnormal
rotation
Normal
rotation
D Polygonal motor rotation status (Motor is rotating in Output
Mode (03))
Abnormal
rotation
Normal
rotation
E- --
F- --
G- --
H- --
[3]
A Bridge unit/Job Separator/Offset Tray connection detection
1
Refer to table 2
B Bridge unit/Job Separator/Offset Tray connection detection
2
Refer to table 2
C Bridge unit/Job Separator/Offset Tray connection detection
3
Refer to table 2
D When bridge unit is
connected
Paper full detection Full Not full
When job separator is
connected
Lower tray paper full
detection
Full Not full
When offset tray is connected Paper full detection Full Not full
E When bridge unit is
connected
Cover opening/closing
switch
Cover opened Cover closed
When job separator is
connected
Cover opening/closing
switch
Cover opened Cover closed
When offset tray is connected Cover opening/closing
switch
Cover opened Cover closed
F When bridge unit is
connected
Paper exit sensor Paper present No paper
When job separator is
connected
---
When offset tray is connected - - -
G When bridge unit is
connected
Intermediate transport
sensor
Paper present No paper
When job separator is
connected
Jam detection sensor Paper present No paper
When offset tray is connected Offset tray timing sensor Paper present No paper
H When bridge unit is
connected
---
When job separator is
connected
Upper tray paper full
detection
Full Not full
When offset tray is connected Offset tray initial position
detection
Initial position Other than
initial position
To Next Page
Loading...
