e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSIS MODES
2 - 10
Table 2. Connecting status of additional options at inner area of the equipment
Table 3. Relation between the status of the original tray width sensor and paper size (width).
H (= high level): Open L (= low level): Short
[8]
A [RADF] Original tray width sensor 1 (TWID0S)
(Refer to table3)
OFF (H) ON (L)
B [RADF] Original tray width sensor 2 (TWID1S)
(Refer to table3)
OFF (H) ON (L)
C [RADF] Original tray width sensor 3 (TWID2S)
(Refer to table3)
OFF (H) ON (L)
D- --
E [RADF] Original length detection sensor Original
present
No original
F [RADF] Original width detection sensor 1 Original
present
No original
G [RADF] Original width detection sensor 2 Original
present
No original
H- --
[9]
A Registration sensor Paper present No paper
B Paper exit sensor Paper present No paper
C Reverse sensor Paper present No paper
D Front cover switch Cover opened Cover closed
E Cassette side cover opening/closing switch Cover opened Cover closed
F Transfer side cover opening/closing switch Cover opened Cover closed
G- --
H- --
[10]
A- --
B- --
C- --
D- --
E- --
F- --
G- --
H- --
None Bridge unit Offset Tray Job Separator
Option connection detection 3 Normal display Normal display Highlighting
display
Highlighting
display
Option connection detection 1 Normal display Highlighting
display
Normal display Highlighting
display
Original tray width sensor
Paper width size
(LT series)
Paper width size
(A4 series)
TWID2S TWID1S TWID0S
H H H LD/LT A3/A4
HHL - B5-R
HLH ST-R A5-R
LHH LD/LT A3/A4
LHL - -
L L H 8.5" x 8.5" / LT-R / LG /
13" LG
A4-R/FOLIO
L L L COMPUTER B4/B5
Digital
key
Button Items to check
Contents
Highlighted
display
e.g.
Normal
display
e.g.
To Next Page
Loading...
