e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 4
E410 Cover open jam Front cover open jam: The front cover has opened
during printing.
P. 6 - 44
E420 PFP side cover open jam: The PFP side cover has
opened during printing.
P. 6 - 44
E430 ADU open jam: The ADU has opened during
printing.
P. 6 - 45
E440 Feed cover open jam: The feed cover has opened
during printing.
P. 6 - 45
E450 LCF side cover open jam: The LCF side cover has
opened during printing.
P. 6 - 46
E480 Bridge unit open jam: The bridge unit has opened
during printing.
P. 6 - 46
E490 Job separator cover open jam: The job separator
cover has opened during printing.
P. 6 - 47
E491 Offset tray cover open jam: The offset tray cover
has opened during printing.
P. 6 - 47
E510 Paper transport jam
(ADU section)
Jam not reaching the ADU entrance sensor: The
paper does not reach the ADU entrance sensor
after it is switchbacked in the exit section.
P. 6 - 32
E520 Stop jam in the ADU: The paper does not reach the
ADU exit sensor after it has passed the ADU
entrance sensor.
P. 6 - 32
E550 Other paper jam Paper remaining jam on the transport path: The
paper is remaining on the transport path when
printing is finished (caused by a multiple paper
feeding).
P. 6 - 33
E570 Paper transport jam Jam not reaching the reverse sensor: The paper
which has passed the exit sensor does not reach
the reverse sensor.
P. 6 - 34
E580 Stop jam at the reverse sensor: The trailing edge of
the paper does not pass the reverse sensor after its
leading edge has reached this sensor.
P. 6 - 34
E712 RADF jam Jam not reaching the registration sensor: The
original fed from the original feeding tray does not
reach the registration sensor.
P. 6 - 48
E714 Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
P. 6 - 48
E721 Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
P. 6 - 48
E722 Jam not reaching the exit sensor (during scanning):
The original which passed the read sensor does not
reach the exit sensor when it is transported from the
scanning section to exit section.
P. 6 - 48
E724 Stop jam at the registration sensor: The trailing
edge of the original does not pass the registration
sensor after its leading edge has reached this
sensor.
P. 6 - 48
E725 Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its
leading edge has reached this sensor.
P. 6 - 49
E731 Stop jam at the exit sensor: The trailing edge of the
original does not pass the exit sensor after its
leading edge has reached this sensor.
P. 6 - 49
E860 RADF jam access cover open: The RADF jam
access cover has opened during RADF operation.
P. 6 - 49
Error code Classification Contents Troubleshooting
To Next Page
Loading...
