Toshiba e-studio205L - Page 409

6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
6 - 5
E870 RADF jam RADF open jam: RADF has opened during RADF
operation.
P. 6 - 49
E871 Cover open jam in the read ready status: Jam
caused by opening of the RADF jam access cover
or front cover while the RADF is waiting for the
scanning start signal from the equipment.
P. 6 - 49
E910 Finisher jam
(Bridge unit)
Jam at the bridge unit transport sensor-1: The
paper does not reach the bridge unit transport
sensor-1 after it has passed the exit sensor.
P. 6 - 50
E920 Stop jam at the bridge unit transport sensor-1: The
trailing edge of the paper does not pass the bridge
unit transport sensor-1 after its leading edge has
reached the sensor.
P. 6 - 50
E930 Jam at the bridge unit transport sensor-2: The
trailing edge of the paper does not reach the bridge
unit transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-1.
P. 6 - 50
E940 Stop jam at the bridge unit transport sensor-2: The
trailing edge of the paper does not reach the bridge
unit transport sensor-2 after its leading edge has
reached the bridge unit transport sensor-2.
P. 6 - 50
E950 Job separator jam Jam not reaching the job separator transport
sensor: The paper has passed through the exit
sensor does not reach the job separator transport
sensor.
P. 6 - 35
E951 Stop jam at the job separator transport sensor: The
trailing edge of the paper does not pass the job
separator transport sensor.
P. 6 - 35
E960 Offset tray jam Jam not reaching the offset tray transport sensor:
The paper has passed through the exit sensor does
not reach the offset tray transport sensor.
P. 6 - 35
E961 Stop jam at the offset tray transport sensor: The
trailing edge of the paper does not pass the offset
tray transport sensor.
P. 6 - 35
E9F0 Finisher jam
(Puncher unit)
Punching jam: Punching is not performed properly.
[MJ-1025 (When MJ-6005 is installed)]
Punching jam: Punching is not performed properly.
[MJ-1024 (when MJ-6004 is installed)]
[MJ-1101 (when MJ-6101 is installed)]
P. 6 - 51
Error code Classification Contents Troubleshooting