HX7+ ASD Installation and Operation Manual 31
FM — This output terminal produces an output current that is proportional to the output frequency of
the ASD or of the magnitude of the function assigned to this terminal. The available assignments for
this output terminal are listed in
Table 15 on page 193. For further information on this terminal, see
F005.
FLA — One of two normally open contacts that, under user-defined conditions, connect to FLC. The
FL relay is the Fault Relay by default, but may be programmed to any of the items of
Table 16 on
page 194. For further information on this terminal, see F132 and Figure 7.
FLB — One of two normally closed contacts that, under user-defined conditions, connect to FLC.
FLC — FLC is the common leg of a single-pole double-throw form C relay.
Note: The FLA, FLB, and FLC contacts are rated at 2A/120 VAC and 2A/30 VDC.
Figure 7. FLA, FLB, and FLC Switching Contacts Shown in the Normal Operating Condition.
Note: The relay is shown in the normal operating condition. During
a faulted condition, the relay connection is FLC-to-FLA.
To Next Page
Loading...
