Toshiba Satellite 4030CDT - Printer Problems

If Something Goes Wrong
Fixing device-related problems
The system does not recognize your PC Card or PCMCIA socket
controller.
This problem may be caused by a low backup battery. Charge the
battery by following these steps:
1 Make sure the computer is not in Resume Mode.
2 Turn off the computer.
3 Connect the AC adapter and power cable and charge the main
battery to 100 percent.
4 Keep the computer plugged in for about seven hours with the
power turned off.
The problem may also be caused by a conflict with any additional
memory in your system.
Often removing a malfunctioning card, inserting it again, and rein
stalling it using the procedure in "Inserting PC Cards" on page 46
can correct many problems.
A PC Card error occurs.
Reinsert the card to make sure it is properly connected.
If the card is attached to an external device, check that the connec
tion is secure.
Refer to the card's documentation, which should contain a trouble
shooting section.
Printer problems
This section lists some of the most common printer problems.
The printer will not print
Check that the printer is connected to a working power outlet and
is turned on and ready (on line).
Check that the printer has plenty of paper. Some printers will not
start printing when there are just two or three sheets of paper left in
the tray.
Parti: Getting To Know Your Computer